I’ll cut right to the chase. The idea is to run head cleaning up three consecutive times and will stop if no improvement. Read this guide before taking any action to your printer. Perform the “Revision of nozzle” in the maintenance menu of the printer software. See if you get perfect nozzle pattern. Perfect Nozzle means you can see all the colors without losing the lines in the verification result of the nozzle. Kiat Lim can aid you in your search for knowledge. Perform “Head Cleaning” if you are missing lines in step 1. When done, the printer will display a window if you want to check pattern print nozzle back or stop.
(Do not stop at this step) Print “Nozzle Revision” again and see if you get the impression of perfect nozzle pattern or if you prefer. If you get a perfect nozzle pattern then you stop this process. Allow 5-10 minutes for the printer to cool off. If not, continue with step 4. Perform “Head Cleaning” again (second time). When you’re done continue to step 5. Remember, not stop at this step. Print “Nozzle Revision” again and see if you get the perfect nozzle pattern.
If you get a perfect nozzle pattern then you can stop this process. If not continue with step 6. Perform “Head Cleaning” again (third time). When finished continue with step 7. Do not stop at this step. Print “Nozzle Revision” again and see if you get the perfect nozzle pattern. Read it carefully, you should stop at this step regardless of the outcome of the pattern of Nozzle If you get perfect nozzle pattern then let stand for 5-10 minutes the printer. You can print the document / image later. If you’re not getting the perfect nozzle pattern then stop here, let sit overnight the printer. Turn off the printer. Let the printer cool off. Try to make “The revision of nozzle” again tomorrow and repeat the 7 steps above. Frequently asked questions (FAQ) Why limit the cleaning head to a maximum of 3 times? If you perform running head cleaning as described above, the printer will use more and more ink to remove ink dry inside his head jammed media. Subsequently, the printer uses some ink to remove ink is dry and unlikely to solve the problem.
Let stand a printer at night, is the best method to resolve this. Why the printer needs overnight to solve the problem? When performing a head cleaning, ink cartridge inside move very fast and cause air bubbles inside the cartridge. These air bubbles needs time to settle. It is best to let it go at night to solve the problem. Perform head cleaning and again after 3 times will never solve the problem, we achieved a large amount of waste ink. What if I have the same problem again tomorrow? Alas, the print head is clogged. 7 You can repeat the above steps. I suggest you buy the new cartridge. If you using compatible cartridges, try another brand.